Contact Us Today

We Are Just A Phone Call Away

DRD Substitute

Pad shown is attached to the 30A Input of the 355, with the AF Cab Reader in the Volts or Amps Menus allows it to function as a DRD for AF cab signal systems.

Note that a Pad is not required for a 0.06 Ohm testing resistance.  Simply using leads of an appropriate length is sufficient.  For 0.06 Ohms, order Lead Set:  330-15

REFDESCRIPTIONPART NO.
10.20 Ohm Resistance355-020
20.25 Ohm Resistance355-025
30.50 Ohm Resistance355-050

200 & 600 Ohm Termination Pads

For use with cable and line circuit maintenance where audio frequency equipment is used to link a central office with outlying locations for controls and indications. Use Pads with the 355 Meter dBu Toggle, to read in decibels instead of VRMS. Toggle switches all AC voltage functions such as the basic voltmeter, Spectrum Analyzer, Min/Max, Electro Scope, etc., to dBu.

REFDESCRIPTIONPART NO.
1600 Ohm Resistance355-600
2200 Ohm Resistance355-200

Rechargeable Battery Retro-fit Kit

Add rechargeable battery capability to Signalman’s Meter.  Adds 2″ in length and 1.5 pounds to 355 Meter.

The kit (shown, less the extended zippered case) includes:

  • 6VDC, 2.9AH Lead Acid Gel Cell
  • Modified battery drawer serving as Connector and Charging Port
  • 6VDC Charger
  • Extended Orange, Zippered Padded Case

REFDESCRIPTIONPART NO.
1Kit, Rechargeable Battery355K-EB001

1000 Ohm/Volt Pad

Pad enables voltage readings to match those of analog signal meters. Permits ground tests with volts readings reported similar to those obtained with analog signaling meters. Mount in Volts terminals. Accommodates shrouded leads without adapters.
REF DESCRIPTION PART NO.
1 Pad, 1000 Ohms/Volt 355-17NR

BNC to Double Banana Adapter

Our 02-3094, BNC to Double Banana Plug Adapter, is available to adapt current clamps or current loops in your inventory that have a millivolt to Amps ratio that our 355 will work with, but the connector cord for which comes with a male BNC connector. Our Adapter includes a standard, female BNC connector. The spacing of the double banana plugs exactly matches the Volts and Common spacing on our Meter. Allows your existing clamp and loop inventory to plug and play.
REF DESCRIPTION PART NO.
1 Adapter, Female BNC, to double banana plug 02-3094

Male BNC to Double Banana Jack Adapter Kit

Our 355-28-18K Kit allows the use of various scopes and other devices equipped with BNC connectors with S&C accessory current clamps and current loops. This Adapter includes a standard, male BNC connector and dual, shielded banana jacks (see above photo). In addition to the Adapter, the Kit includes an 8 foot set of leads with straight, shielded banana plugs on both ends.
REF DESCRIPTION PART NO.
1 Kit Adapter, Male BNC to Double Banana Jack and set of Leads 8 ft., shielded banana plugs 355-28-18K

View Master Sun Guard

Accessory shown mounted to our new 350 Signal Test Meter. Guard is snap-on. Access to Push Buttons provided with cutout that is protected, preventing daylight leakage into display area.
REF DESCRIPTION PART NO.
1 View Master Sun Guard 355-1824

Back to Signalman’s Meter Current Clamp & Other Accessories